FPV Starter Build: Frames, Stacks, Motors, VTX and Props

FPV Starter Build: Frames, Stacks, Motors, VTX and Props

Everything a first FPV quad needs, in one place. This page pulls together the FPV shelves at Quality RC Parts: frames, flight controller and ESC stacks, motors, propellers, video gear, radios and receivers, and the batteries that power them. Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping.

The parts every FPV build needs

A flying quad has seven jobs to cover. Miss one and the build waits on the bench. The table below shows where each part lives in the store.

JobWhat to shopStart here
FrameFPV drone frames, large framesFPV Drone Frames
Flight controlFlight controllers and ESC stacksFlight Controllers & ESCs
Motors and propsBrushless motors, propellers, prop adaptersFPV Motors
VideoCameras, VTX, antennas, goggles and monitorsFPV Video Transmission
Radio linkTransmitters, receivers, ELRS gearRadios & Receivers
PowerLiPo batteries, chargers, BECs, connectorsBatteries & Chargers
FinishHardware, straps, heat shrink, toolsParts & Hardware

Start with the frame

Frame size sets motor size, prop size, and battery size, so pick the frame first. Micro frames suit indoor flying. Five inch frames are the common freestyle and racing size. Large frames carry bigger motors and heavier camera gear. Check motor mounting pattern and stack mounting size before ordering parts to fit the frame.

Stack, motors and props

The flight controller and ESC stack is the brain and muscle of the quad. Match motor KV and prop size to the frame and battery cell count, and check that the stack fits the frame mounting holes. Prop adapters let a motor run props with a different center hole. Spare props are worth ordering with the build, since props are the first part to break in a crash.

Video and radio

Video gear and radio gear must match what is already owned. Check VTX power and antenna connector, camera size and voltage, and receiver protocol before ordering. ELRS receivers and modules need a matching ELRS transmitter or module. Goggles and monitors must match the VTX signal type, analog or digital.

Power it right

Battery cell count, capacity, and connector must match the motors, ESCs, and charger. See the Power and Charging page for batteries, chargers, BECs, and connectors, and check cell count and connector on every product page before ordering.

Guides before you buy

See the Drone Guides hub for FPV build and buying guides. Not sure parts fit together? Ask a tech before you order and include the frame size and battery you plan to use.