Description
This 3-pack of AS5600 magnetic encoder modules gives you three 12-bit contactless angle sensors for brushless gimbal motors, robot joints and stepper closed-loop builds. Each module reads the angle of a diametrically magnetized magnet spinning above the chip, so there is no contact and no wear. Each module outputs I2C, PWM and analog voltage.
Type: AS5600 magnetic rotary position sensor module on a white 23 x 23 mm board, 3.3V supply. Compatibility: works with Arduino, Raspberry Pi, ESP32 and STM32 boards, and with SimpleFOC and other FOC motor control setups. Mount each included magnet on the motor shaft above the chip and wire VCC, GND, OUT, DIR, SCL, SDA and GPO through the included 7-pin headers.
In the box: 3x AS5600 encoder modules, 3x diametric magnets, 3x 7-pin headers.
Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping.









Reviews
There are no reviews yet.