Description
Three ESP32 development boards with a USB-C interface and 38 pins, each paired with a breakout terminal adapter board. The breakout board expands one GPIO pin of the ESP32 board to two, so every pin can be reused, on a double-layer board wired on both sides for a stable, reliable connection.
Each board integrates an antenna, RF balun, power amplifiers, low noise amplifiers, filters, and power management, with 2.4 GHz WiFi and Bluetooth dual-mode, STA/AP/STA+AP modes, and common AT commands. The narrower width connects to a breadboard very well. Note: the breakout boards fit 38-pin narrow versions with no mounting holes only.
Specifications
- Quantity: 3 ESP32 development boards and 3 breakout adapter boards
- Boards: 38-pin, narrow width, USB-C (Type-C), ESP-WROOM-32 module
- Wireless: 2.4 GHz WiFi + Bluetooth dual-mode, STA/AP/STA+AP, AT commands
- Breakout: expands one GPIO pin to two, double-layer board, for 38-pin narrow no-mounting-hole boards
In the box
Three ESP32 development boards and three ESP32 breakout adapter boards.
How to use it
Plug a board into a breadboard, connect USB-C, and run a blink sketch in the Arduino IDE or MicroPython. Then run a WiFi scan to confirm wireless works. The breakout adapter expands each GPIO pin to two so a pin can feed two connections at once.
Pairs with
A breadboard and a short USB-C cable complete the bench setup. See ELEGOO 830-point breadboard 3-pack and short USB-C cable 1ft 2-pack.
Compare
The HiLetgo 3-pack is the same 38-pin USB-C board without breakout adapters. Alternative: HiLetgo ESP32 38-pin 3-pack.
Full comparison: ESP32 38-pin boards compared.
Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping.







Reviews
There are no reviews yet.