Description
This Arducam pan tilt platform is a two-axis camera mount for Raspberry Pi and Nvidia Jetson builds. It pans and tilts your camera up to 180 degrees on each axis, so one camera covers far more ground than a fixed mount. It fits Raspberry Pi Camera Modules V1, V2 and V3, Arducam 16MP, 64MP and Mini HQ cameras, and Nvidia Jetson boards.
Arducam pan tilt platform with 180-degree pan and tilt
Two GH-S37D digital servos drive the platform with faster speed, higher torque and better holding than analog servos. The included I2C PWM controller board drives both servos directly, so wiring stays simple: the board takes the I2C signal and outputs the PWM the servos need. Mount the camera on the base bracket, connect the board, and drive it from your Pi or Jetson.
Specifications
- Brand: Arducam
- Pan range: 180 degrees
- Tilt range: 180 degrees
- Servos: 2x GH-S37D digital servos, 20 x 8.75 x 22 mm, torque 0.6 kg/cm at 3.6V, 0.8 kg/cm at 4.8V
- Control board: 12-bit PWM controller board, I2C, 38 x 28 mm, 4 jumper wires included
- Compatibility: Raspberry Pi Camera Module V1, V2, V3; Arducam 16MP, 64MP and Mini HQ cameras; Nvidia Jetson boards
- Camera included: No, camera not included
Compatibility
Fits Raspberry Pi Camera Modules V1, V2 and V3, Arducam 16MP, 64MP and Mini HQ cameras, and Nvidia Jetson boards. Works with all Raspberry Pi models. Camera not included.
In the box
1x pan tilt bracket kit, 2x GH-S37D digital servo motors, 1x PTZ controller board with 4 jumper wires, 1x pack of screws. Camera not included.
Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping.








Reviews
There are no reviews yet.