Description
All-in-one portable power for bench and field projects. The module packs a built-in 1200mAh rechargeable LiPo battery, a boost converter, and a 3.3V regulator onto one compact 56 x 40mm board. No soldering and no external battery packs. Plug in and power your Arduino, ESP32, or Raspberry Pi project.
Three output rails cover most builds: 5V/1.2A through the header and the USB-A port, 3.3V/800mA through the header, and direct battery output through the JST PH2.0 connector. USB-C pass-through mode powers your project directly from USB while keeping the battery disconnected, so bench-top development does not wear out the battery.
Charging runs through USB-C and takes about 1 hour. Both C-to-C and A-to-C cables work. Four onboard LEDs show remaining charge at 25, 50, 75, and 100 percent, and the ON/OFF switch cuts power when the project is packed away.
Built-in protection covers overcharging, reverse polarity, and overload. Note: this module does not support UPS operation, so it will not hold a project up through a power cut.
Specs:
- Battery: built-in 1200mAh 3.7V LiPo, 4.44Wh
- Outputs: 5V/1.2A (header + USB-A), 3.3V/800mA (header), direct battery (JST PH2.0)
- Charging: USB-C, about 1 hour, C-to-C and A-to-C cables supported
- Pass-through: USB-C powers the project with the battery disconnected
- Gauge: 4 LEDs, 25/50/75/100 percent
- Protection: overcharge, reverse polarity, overload
- Board size: 56 x 40mm
- Switch: ON/OFF
- Works with: Arduino, ESP32, Raspberry Pi projects
Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping. I check every order before it ships.
See also: Batteries & Chargers · ELEGOO UNO R3 Microcontroller Board, ATmega328P + ATmega16U2, with USB Cable · Nano V3.0 Development Board, ATmega328P, CH340G, USB-C, Single · 3.7V 3000mAh LiPo Battery, 1S, JST 1.25 Plug, for ESP32 and Arduino Boards, 4-Pack · How to Power ESP32 and Arduino Projects on LiPo Power
Reviews
There are no reviews yet.