Description
Three narrow-version ESP32 development boards with 38 pins and a USB-C interface, each paired with a breakout board. The narrower width is compatible with breadboards, and the breakout board expands one GPIO pin to two so every pin can be reused in smart home and DIY projects.
The boards support Lua programs and three wireless modes: AP, STA, and AP + STA. Note: the breakout boards fit 38-pin narrow-version ESP32 boards without mounting holes only, and do not fit the ESP32 DevKit V1 version. Check that the board pin width matches the breakout board pin width before ordering.
Specifications
- Quantity: 3 ESP32 development boards and 3 breakout boards
- Boards: 38-pin narrow version, USB-C, WiFi + Bluetooth
- Wireless modes: AP, STA, AP + STA; Lua program support
- Breakout: expands one GPIO pin to two; fits 38-pin narrow boards without mounting holes only
In the box
Three ESP32 development boards and three ESP32 breakout boards.
How to use it
Plug a board into a breadboard, connect USB-C, and run a blink sketch in the Arduino IDE or MicroPython. Then run a WiFi scan to confirm wireless works. Check that the board pin width matches the breakout board before fitting it, since the breakout boards fit 38-pin narrow boards without mounting holes only.
Pairs with
A breadboard and a short USB-C cable complete the bench setup. See ELEGOO 830-point breadboard 3-pack and short USB-C cable 1ft 2-pack.
Compare
The HiLetgo 3-pack is the same 38-pin USB-C board without breakout boards. Alternative: HiLetgo ESP32 38-pin 3-pack.
Full comparison: ESP32 38-pin boards compared.
Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping.








Reviews
There are no reviews yet.