
A GPS module does two jobs on a drone: it tells the flight controller where the aircraft is, and its compass tells the flight controller which way the aircraft is pointing. Get either one wrong and return to home flies the wrong way, position hold drifts, and autonomous missions fail. A new GPS module landed at Quality RC Parts today, and it joins a full shelf of live GPS options. This guide compares the whole shelf so you can match the module to your flight controller and your flying.
The new module: FK-D1 M9
The FK-D1 M9 GPS Module with QMC5883L Compass for Pixhawk and ArduPilot is $24.99. It is built for Pixhawk, ArduPilot, and other flight controllers that take a serial GPS with compass. The M9 chip tracks 32 satellites across GPS, Galileo, BeiDou, GLONASS, and QZSS at the same time, with a native 25 Hz update rate and 2 meter positioning accuracy. More satellites tracked at once means a faster lock and a steadier hold when part of the sky is blocked by trees or buildings.
The built in QMC5883L geomagnetic compass talks over I2C on SCL and SDA, so the flight controller gets heading from the same module. Wiring is a 6-pin SH1.0 connector: GND, 5V, Rx, Tx, SCL, SDA. Connect Rx to the flight controller Tx pin and Tx to the flight controller Rx pin. UART runs at 3.3V TTL level with a default baud rate of 115200, and 4800 to 921600 is supported. NMEA and UBX protocols are both available.
The 25 x 25 mm tri-band ceramic antenna gives minus 167 dBm tracking sensitivity with a built in high gain low noise amplifier. Cold start is 24 seconds and hot start is 1 second. The module draws 80 mA at 5V, works from 3.6 to 5.5V, and is rated from minus 40 to plus 85C. A blue PPS LED flashes once the module has a 3D fix, so you can confirm lock without a ground station. Size is 25 x 25 x 8 mm and weight is 12 grams.
The full shelf compared
| Module | Chip | Compass | Update rate | Best for | Price |
|---|---|---|---|---|---|
| FK-D1 M9 | M9, 32 satellites | QMC5883L | 25 Hz | Pixhawk / ArduPilot, best value | $24.99 |
| RadioLink M10N SE100 | M10N | IST8310 | 10 Hz class | Pixhawk, proven RadioLink stack | $49.99 |
| M10 with QMC5883L | M10 | QMC5883L | 10 Hz | FPV and fixed wing | $30.99 |
| M10 Mini | M10 | None listed | 10 Hz | Tight FPV builds, 18 mm size | $28.99 |
| M9140 9th gen GNSS | 9th gen GNSS | IST8310 | 25 Hz | FPV and fixed wing, fastest budget pick | $21.99 |
| BN-880 | GNSS | HMC5883L | Standard | Pixhawk, Betaflight, Arduino, Raspberry Pi | $43.99 |
Pixhawk and ArduPilot builds
For a Pixhawk or ArduPilot build, pick a module with a compass built in and a serial connection your flight controller expects. The FK-D1 M9 at $24.99 is the value pick: 25 Hz updates, 32 satellites, and a QMC5883L compass in a 12 gram package. The RadioLink M10N SE100 GPS Module with IST8310 Compass for Pixhawk Flight Controllers at $49.99 is the proven RadioLink option with the IST8310 compass, and it is the pick if you want the RadioLink stack end to end. The BN-880 GPS Module with HMC5883L Compass and Active Antenna for Pixhawk, Betaflight, Arduino, and Raspberry Pi at $43.99 is the flexible pick: it works across Pixhawk, Betaflight, Arduino, and Raspberry Pi, with an active antenna and the HMC5883L compass.
On ArduPilot, set the GPS baud to match the module, enable the compass, and run the compass calibration before the first armed flight. Do the calibration outdoors, away from cars and metal benches, and rotate the aircraft through all axes until the ground station reports a good fit. A bad compass calibration is the most common cause of a toilet bowling position hold, and it is fixed on the bench, not in the air.
FPV and fixed wing builds
FPV and fixed wing aircraft need less from a GPS module: position, speed, and a home arrow are usually enough, and the flight controller is often Betaflight or iNav rather than ArduPilot. The M10 GPS Module with QMC5883L Compass, 10Hz, for FPV Drones and Fixed Wing Aircraft at $30.99 covers that job with a 10 Hz update and a QMC5883L compass. The 9th Gen GNSS GPS Module with IST8310 Compass, 25Hz, for FPV Drones and Fixed Wing UAV at $21.99 is the cheapest 25 Hz option on the shelf and the best budget pick for a fast update rate. The M10 Mini FPV GPS Module, 18mm, 10Hz, for FPV Racing Drones and Fixed Wing at $28.99 is the pick when space is tight: 18 mm across, 10 Hz, built for small racing quads where every millimeter of stack space is already spoken for.
On FPV builds, mount the GPS on top of the frame with a clear view of the sky and keep the antenna away from the video transmitter, which is the loudest RF source on the aircraft. A GPS that sits under a carbon plate or next to a VTX will take longer to lock and hold fewer satellites. If your build has a compass, keep it away from power wires and motors too: current in a wire makes a magnetic field, and the compass cannot tell that field apart from the earth.
Compass notes that save a crash
Three rules cover most compass trouble. First, mount the module level and pointing forward, and tell the flight controller the mounting orientation if it is rotated. Second, calibrate after every mount change, including moving the module to a new frame. Third, check the compass against the real heading before you arm: point the nose north and confirm the ground station agrees. If it reads south, the orientation setting is wrong, and return to home will fly away from home. Fix it on the ground.
LoRa: what it adds for telemetry and tracking
GPS tells the aircraft where it is. LoRa tells you where it is. A LoRa link carries small packets a long way on very little power, which is exactly what telemetry and tracking need: position, battery, and status, sent back to the ground over kilometers instead of hundreds of meters. The Seeed Studio XIAO ESP32S3 and Wio-SX1262 Meshtastic LoRa Dev Kit, Without Case is $24.49 and it pairs the XIAO ESP32S3 microcontroller with the Wio-SX1262 LoRa radio for Meshtastic mesh networking. Meshtastic nodes relay each other, so a network of nodes covers more ground than any single link. It is a solid companion to a GPS module on a long range fixed wing, a rover, or a tracker build where WiFi and Bluetooth run out of range.
More GPS and LoRa options are being sourced now and will land on the store soon. Check the GPS and telemetry sections for the latest stock.
How to pick
For a Pixhawk or ArduPilot aircraft, buy the FK-D1 M9 for value or the RadioLink M10N for the proven stack, and buy the BN-880 if the same module has to work across flight controllers and bench projects. For FPV or fixed wing, buy the M9140 for the fastest budget update rate, the M10 for a solid all rounder with compass, or the M10 Mini when the frame is small. Then mount it high, keep it away from power and video RF, calibrate the compass, and confirm the heading before the first flight. All of these modules ship fast and securely from our secure facility in New York, providing fast, high quality USA shipping. Related reading: our Best GPS and Telemetry Modules for ArduPilot guide and our drone telemetry modules guide cover the wider telemetry picture these GPS modules fit into.
