Description
Two USB to ESP-01 programmer adapters with a handy rocker switch on the side. The ESP-01 serial WiFi module plugs directly into the yellow pin header without any connection wires. An on-board toggle switch selects the working mode: the UART side for serial TTL debugging with AT commands, or PROG for firmware programming.
The USB to serial TTL chip is the CH340G; install the driver before use. Baud rate 115200, operating voltage 4.5-5.5 V.
Specifications
- Quantity: 2 USB to ESP-01 adapters
- Chip: CH340G USB to serial TTL, driver install required
- Baud rate: 115200, voltage 4.5-5.5 V
- Mode switch: UART side for AT command debugging, PROG side for firmware programming
- ESP-01 plugs directly into the yellow pin header, no connection wires
In the box
Two USB to ESP-01 adapters. ESP-01S module is not included.
How to use it
Install the CH340G driver, plug the ESP-01 module into the yellow pin header, and set the switch to PROG to flash firmware or UART for serial debugging with AT commands. No connection wires are needed.
Pairs with
ESP-01S modules plug straight into this adapter. See ESP-01S WiFi module 4MB and ESP-01S WiFi module 5-pack 1MB.
Compare
The CH340C adapter adds an auto-download circuit so no mode switch is needed. Alternative: USB ESP-01 programmer adapter 2-pack.
Full comparison: ESP-01 and ESP-01S getting started.
Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping.








Reviews
There are no reviews yet.