Description
Three ESP8266 NodeMCU development boards with the ESP-12E module and a CP2102 USB interface. The CP2102 interface programs the board without pressing the flash and reset buttons before each flash operation.
NodeMCU is open-source Lua based firmware for the ESP8266, for ultra low cost wireless modules and rapid prototyping. The ESP8266 has powerful on-board processing and storage and integrates with sensors and other devices through its GPIOs. Compatible with Arduino IDE, Mongoose IoT, and MicroPython.
Specifications
- Quantity: 3 NodeMCU development boards, ESP-12E module
- USB: CP2102 interface, no flash/reset button presses needed before flashing
- Firmware: open-source NodeMCU Lua firmware for ESP8266
- Works with Arduino IDE, Mongoose IoT, MicroPython
In the box
Three ESP8266 NodeMCU development boards.
How to use it
Plug in USB, select the NodeMCU board in the Arduino IDE, and flash without pressing the flash and reset buttons first. Run a blink sketch, then a WiFi scan or a small sensor project.
Pairs with
A breadboard and jumper wires connect sensors to the board. See ELEGOO 830-point breadboard 3-pack and ELEGOO Dupont jumper wire set.
Compare
The HiLetgo CP2102 3-pack is the same chip and pack size with flash and reset switches on board. Alternative: HiLetgo ESP8266 NodeMCU CP2102 3-pack.
Full comparison: ESP8266 NodeMCU compared: CH340 vs CP2102.
Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping.








Reviews
There are no reviews yet.