Description
A Raspberry Pi Pico with pre-soldered header, built around the RP2040 microcontroller chip designed by Raspberry Pi in the United Kingdom. The dual-core Arm Cortex M0+ processor runs at a flexible clock up to 133 MHz, with 264 KB of SRAM and 2 MB of on-board flash memory.
The castellated module allows soldering direct to carrier boards. USB 1.1 with device and host support, low-power sleep and dormant modes, and drag-and-drop programming using mass storage over USB. 26 multi-function GPIO pins, 2 x SPI, 2 x I2C, 2 x UART, 3 x 12-bit ADC, 16 controllable PWM channels, an accurate on-chip clock and timer, a temperature sensor, accelerated floating-point libraries, and 8 programmable I/O (PIO) state machines.
Specifications
- Chip: RP2040, dual-core Arm Cortex M0+, up to 133 MHz
- Memory: 264 KB SRAM, 2 MB on-board flash
- GPIO: 26 multi-function pins
- Interfaces: 2 x SPI, 2 x I2C, 2 x UART, 3 x 12-bit ADC, 16 PWM channels, 8 PIO state machines
- USB 1.1 host and device, drag-and-drop programming over USB mass storage
- On-chip clock and timer, temperature sensor, accelerated floating-point libraries
- Pre-soldered header, castellated module
In the box
One Raspberry Pi Pico board with pre-soldered header.
How to use it
Plug the board into a breadboard with the pre-soldered header, hold BOOTSEL, plug in USB, and drag the MicroPython UF2 file onto the drive that appears. Then run a blink script in Thonny.
Pairs with
Spare headers and a case finish the board. See pin header set 30-piece for Pico and C4Labs Zebra Pico case.
Compare
The 2-pack gives two bare Pico boards for soldering headers onto. Alternative: Raspberry Pi Pico 2-pack.
Full comparison: Raspberry Pi Pico vs Pico W vs Pico 2.
Shipped fast and securely from our secure facility in New York, providing fast, high quality USA shipping.









Reviews
There are no reviews yet.